SawStop RT-TGP Owner's Manual page 28

Insert a socket head cap screw (4.6)
11
through a lock washer (4.5) and then
through one of the exposed holes in the
leg mounting bracket and router table.
Use a 5mm hex wrench to tighten the
screw. Repeat this process for the other
hole in the leg mounting bracket that
lines up with a threaded hole in
the table.
Repeat the previous two steps with
12
the other support leg and leg mounting
bracket, but install it on the other end of
the router table.
Next, install the router table in one of the three in-line configurations for your Professional Cabinet
Saw or Contractor Saw with T-Glide Professional Series II (TGP2) rails and cast iron wings. See
page 2-4 for details regarding the configurations and the figures on page 27 for the correct rail
requirements.
•
For mounting in-line left of the left wing on a Professional Cabinet Saw or Contractor Saw,
proceed to the next page.
i
The router table is only compatible with the Contractor Saw if cast iron wings are
installed on the saw. The standard stamped metal wings on the Contractor Saw
cannot support the weight of the router table.
•
For mounting in-line right: between Professional Cabinet Saw 36" rails, with or without
the optional intermediate cast iron wing, verify your rails on page 27 and then proceed to
page 28.
•
For mounting in-line right: between Professional Cabinet Saw 52" rails, verify your rails on
page 27 and then proceed to page 34.
23
RT-TGP/RT-BT OWNER'S MANUAL
4.6
4.5
stamped
wing