SawStop RT-TGP Owner's Manual page 21

Next, attach the tool storage plate (D) to
7
the left side of the stand, and attach the
handle mounting bracket (P) at the front
edge of the plate. Insert a carriage head
bolt (M) through the handle mounting
bracket (P) and tool storage plate (D),
then through the hole in the front, left
stand leg (H). Secure the bolt with a
washer (J) and a hex nut (I).
Attach the other side of the tool storage
plate (D) to the other stand leg (H) using
another carriage head bolt (M), washer
(J), and hex nut (I).
The shaft of the elevation handle for
your router lift can be inserted through
the holes in the tool storage plate in
order to store the elevation handle.
8
Use a 10mm wrench to tighten the 34 nuts on the bolts in the stand legs.
Thread a hex nut (O) partway onto each
9
of the two pan head Phillips screws (N),
then thread the screws into each of the
two threaded holes near the front end
of the tool storage plate. Use a Phillips
screwdriver to hold the screws still, and
use an 8mm wrench to tighten the nuts
against the tool storage plate.
D
P
M
D
N
O
RT-TGP/RT-BT OWNER'S MANUAL
I
J
FRONT-LEFT
STAND LEG (H)
P
16