SawStop RT-TGP Owner's Manual page 20

Assemble the rear of the stand by
4
attaching the remaining two stand legs
(H) to the remaining upper front/rear
bracket (A) and the rear panel (B). Make
sure that the bracket and panel are on
the outside of the legs. Attach the legs
to the bracket and panel using eight
carriage head bolts (M), eight washers
(J), and eight hex nuts (I). Only finger
tighten the nuts. If you are planning
on installing the Downdraft Dust
Collection Box, wait to install
the rear panel (B) until after you
have installed the Downdraft Dust
Collection Box.
Attach one of the upper side brackets
5
(C) and lower side brackets (E) between
the front and rear portions of the stand
using eight carriage head bolts (M),
eight washers (J), and eight hex nuts (I).
Make sure that the brackets are on the
outside of the legs. Do not fully tighten
the nuts.
Repeat the prior step to attach the
6
remaining upper side bracket (C) and
lower side bracket (E) to the opposite
side of the stand.
15
RT-TGP/RT-BT OWNER'S MANUAL
J
I
B
C
E
A
M
H
I
J
C
M
E