Parts & Hardware Lists - SawStop RT-TGP Owner's Manual

Intermediate Cast Iron Wing
A.
Intermediate Cast Iron Wing (1)
B.
M8 x 1.25 x 25 Flat Head Socket Screw (2)
C.
M8 x 20 x 2 Washer (10)
D.
M8 Lock Washer (6)
E.
M8 x 1.25 Hex Nut (6)
F.
M8 x 1.25 x 35 Hex Head Bolt (4)
You will also need the following tools to complete the Intermediate Cast
Iron Wing assembly:
•
13mm Wrench (x2)
•
5mm Hex Wrench
See Exploded View #6 on page 59 for more information.
i
Important Part Identification Note:
Throughout the manual, the exploded views are referenced to clarify the location and
name of each part. There are multiple exploded views in this manual, so a
decimal point system is used. The number before the decimal point refers to the
exploded view number (in this case, 1 through 6). The number after the decimal point
refers to the part number (as indicated by the number in the balloon in the exploded
view). For example, a part referenced as "1.1" would be the part labeled with a "1.1"
balloon in the exploded view #1.
•
Exploded View #1: 27" x 16" Cast Iron Router Table – See page 49
•
Exploded View #2: Benchtop Stand for Router Table – See page 51
•
Exploded View #3: Support Legs for In-Line Router Tables – See page 53
•
Exploded View #4: 32" Power Switch for In-Line Router Tables – See page 55
•
Exploded View #5: 27" Fence Assembly for Router Tables – See page 57
•
Exploded View #6: Intermediate Cast Iron Wing – See page 59
RT-TGP/RT-BT OWNER'S MANUAL
A
B
C
D
E
F
10