SawStop RT-TGP Owner's Manual page 52

6. Always wear safety glasses when using the Benchtop Router Table Assembly/
TGP2 In-Line Router Table Assembly. Also use a face or dust mask if the cutting
operation is dusty. Everyday eyeglasses are not safety glasses.
7. Keep hands away from router bits. Never reach around or over the router. Use
feather boards and/or push sticks to keep your hands away from the router bit.
Keep proper footing and balance at all times.
8. Always run your workpiece against the rotation direction of the router bit. Never
cut pieces between the fence and the router bit.
9. Always ensure the router bit is in good working condition before use. Examine the
router bit prior to use and replace the bit if it is damaged.
10. Ensure the TGP2 In-Line Router Table Assembly is installed securely when
mounted in-line on your Professional Cabinet Saw or Contractor Saw. If you are
using the Benchtop Router Table Assembly with the benchtop stand, be sure that it
is secured to a table or work surface before use.
11. Maintain the Benchtop Router Table Assembly/TGP2 In-Line Router Table
Assembly as specified in this manual. Use only identical replacement parts
when servicing the Benchtop Router Table Assembly/TGP2 In-Line Router Table
Assembly.
12. Turn the power disconnect switch to OFF before servicing the Benchtop Router
Table Assembly/TGP2 In-Line Router Table Assembly or router. Always ensure the
power is OFF before changing components or accessories such as router bits,
guards, and the like.
13. Check to make sure the Benchtop Router Table Assembly/TGP2 In-Line Router
Table Assembly is in proper working order before use. For example, check
the alignment of moving parts, look to see whether moving parts are binding
or rubbing, check to see whether parts are broken, make sure accessories are
properly mounted in the saw, and check any other conditions that may affect the
operation of the Benchtop Router Table Assembly/TGP2 In-Line Router Table
Assembly. Any parts that are damaged should be properly repaired or replaced.
14. Never use the Benchtop Router Table Assembly/TGP2 In-Line Router Table
Assembly if your saw is raised off the floor (i.e. if the wheels on a mobile base are
supporting the saw) and the Benchtop Router Table Assembly/TGP2 In-Line Router
Table Assembly is installed in the in-line configuration.
47
RT-TGP/RT-BT OWNER'S MANUAL