SawStop RT-TGP Owner's Manual page 27

Next, install the screw that is used to
8
store the insert wrench that comes with
your router lift. Insert the longer pan
head Phillips screw (4.8) through one of
the two smaller lock washers (4.9) and a
washer (4.10), then all the way through
the back of the remaining small hole in
the front of the leg mounting bracket.
Use a Phillips screwdriver to secure
the screw.
You will now attach the support legs
9
to the underside of your router table.
Place your table upside-down on a flat
surface. Find the two sets of threaded
holes near the front of the table. The
leg mounting brackets can each be
installed on either the left or right side
of your table, depending on the user's
preference regarding the location of the
switchbox.
Position one of the leg mounting
10
brackets (and attached support leg)
upside-down above the router table,
with the front of the leg mounting
bracket (either the switchbox or the
handle mounting bracket) facing
towards the front of the table so it will
be accessible when the table is flipped
back over and installed on your saw.
4.10
RT-TGP/RT-BT OWNER'S MANUAL
4.8
4.9
22