SawStop RT-TGP Owner's Manual page 25

i
The hardware for the following steps can be found in the "Leg Mounting Hardware" bag from the Power
Switch for In-Line Router Tables box.
Align two holes in one of the support
2
legs with the two holes on the inside of
the right edge of the in-line switch box
mounting bracket assembly (4.1) (from
the perspective of the front of the power
switch).
Insert a hex head bolt (4.2) through a
3
washer (4.3), then through one of the
exposed mounting holes in the bracket
(4.1) and support leg (3.1), through
another washer (4.3), and then through
a lock nut (4.4). Repeat this process for
the other set of exposed mounting holes
in the bracket and support leg. Use two
17mm wrenches to tighten the lock nuts
on the bolts.
Align two of the holes in the other
4
support leg with the two holes on the
left side of the leg mounting bracket
(4.7) (from the perspective of the flat
edge of the bracket).
4.1
3.1 4.3
4.7
RT-TGP/RT-BT OWNER'S MANUAL
4.4
4.3
4.1
4.2
20