Assembling The Benchtop Stand - SawStop RT-TGP Owner's Manual

Assembling the Benchtop Stand for Router Table
Requires:
Components and Hardware for Benchtop Stand
Phillips Head Screwdriver
8mm Wrench
10mm Wrench
Benchtop Stand for Router Table Hardware Pack
THE BENCHTOP STAND SHOULD ONLY BE USED ON A FLAT SURFACE (SUCH
AS A STURDY WORK BENCH) THAT IS STABLE AND STRONG ENOUGH TO
SUPPORT THE COMBINED WEIGHT OF THE ROUTER, CAST IRON TABLE,
BENCHTOP STAND, AND WORKPIECE.
THE BENCHTOP STAND SHOULD NEVER BE PLACED NEAR THE EDGE OF AN
ELEVATED SURFACE (SUCH AS A BENCHTOP OR TABLE), SINCE IT COULD
FALL AND CAUSE SERIOUS DAMAGE AND/OR PERSONAL INJURY.
THE BENCHTOP STAND CAN BE USED IN TWO DIFFERENT WAYS:
1. THE RUBBER SUPPORT FEET (INCLUDED) CAN BE INSTALLED AT THE
BASE OF ALL FOUR STAND LEGS. THE SUPPORT FEET CAN HELP
PREVENT THE BENCHTOP STAND FROM SHIFTING.
2. THE RUBBER SUPPORT FEET (AND ACCOMPANYING HARDWARE) CAN BE
SET ASIDE, AND ALTERNATE HARDWARE (NOT INCLUDED) CAN BE USED.
IN THIS CASE, DRILL FOUR HOLES IN YOUR WORK BENCH OR TABLE
THAT ALIGN WITH THE FOUR HOLES IN THE BASES OF THE STAND LEGS,
ALIGN THE BENCHTOP STAND WITH THOSE HOLES, AND MOUNT THE
BENCHTOP STAND TO THE TABLE USING A BOLT, TWO FLAT WASHERS, A
LOCK WASHER, AND A HEX NUT (OR A BOLT, TWO FLAT WASHERS, AND A
LOCK NUT) ON EACH STAND LEG.
13
RT-TGP/RT-BT OWNER'S MANUAL