SawStop RT-TGP Owner's Manual page 19

Using your Benchtop Stand Hardware
1
Pack and labeled parts, insert one of
the four, pan head Phillips screws (L) up
through a support foot (K), then through
the hole in the bottom of a stand leg
(H), a washer (J), and a hex nut (I). Use
a Phillips screwdriver and a 10 mm
wrench to tighten the hex nut. Repeat
this process for the remaining three
stand legs.
Arrange the upper front/rear brackets
2
(A), upper side brackets (C), stand legs
(H), front panel (F), rear panel (B), lower
side brackets (E), and tool storage plate
(D) on a flat surface (such as a floor or
table). All of the brackets and panels will
be attached to the outside of the stand
legs, and all the folded sections will
extend in between the stand legs.
Assemble the front of the stand by
3
attaching two of the stand legs (H) to
an upper front/rear bracket (A) and
the front panel (F). Make sure that the
legs are behind the bracket and panel.
Attach the legs to the bracket and panel
using eight carriage head bolts (M),
eight washers (J), and eight hex nuts
(I). Only finger tighten the nuts at this
time. Leaving the nuts loose will make
it easier to align holes as you assemble
the rest of the stand.
H
I
J
K
L
B
E
C A
D
F
F
RT-TGP/RT-BT OWNER'S MANUAL
x4
H
C E
A
H
I
J
M
14