SawStop RT-TGP Owner's Manual page 41

Remove the C-clamps and the
4
extension table. Use a 3/8" drill bit to
drill holes in the extension table in the
locations you marked in the
previous step.
Follow the instructions in your table
5
saw fence manual to install the 36"
extension table between your 52" rails.
Align the router table (with attached
6
support legs) with the right edge of the
36" extension table. Make sure that the
tops of the router table and extension
table are flush.
There are two sets of holes in the edge
7
of your router table. Mark the 36"
extension table in the center of each
of the three lower holes in the router
table. Then set the router table (and
attached support legs) aside.
For this step, please refer
to your table saw fence manual.
RT-TGP/RT-BT OWNER'S MANUAL
36