SawStop RT-TGP Owner's Manual page 34

The intermediate cast iron wing is
2
shipped with a coating of oil to prevent
the cast iron from rusting. Remove the
protective covering wipe the oil off with
a soft, clean cloth. The wing comes
with hardware to mount it to the right
extension wing of your Professional
Cabinet Saw.
Align four of the holes in the
3
intermediate cast iron wing (indicated
by the red arrows) with the four
holes in the left extension wing of
your Professional Cabinet Saw. The
chamfered edge of the intermediate
cast iron wing should align with the
chamfered edge of the front of the
extension wing, and the hole in each
end of the intermediate cast iron wing
should align with holes in the front
and rear rails.
i
The hardware for the next steps can be found in the hardware bag that came with the intermediate cast
iron wing.
Mount the intermediate cast iron wing
4
to the extension wing using four hex
head bolts (6.6), eight washers (6.3),
four lock washers (6.4), and four hex
nuts (6.5). Insert the four hex head bolts
through four washers, then through the
intermediate cast iron wing and extension
wing. Then install four washers, four lock
washers, and four hex nuts (in that order)
on the bolts. Only finger tighten the
nuts at this time.
29
RT-TGP/RT-BT OWNER'S MANUAL
6.1
6.6
6.3
6.4
6.5
6.1