SawStop RT-TGP Owner's Manual page 17

Finger tighten the hex nuts up against
4
the bottom of the table. You will adjust
the screws and fully tighten the hex nuts
later, after you install your router lift.
If you plan on installing the router table
5
in-line on your SawStop Professional
Cabinet Saw and you have the ICS
Mobile Base with PCS Conversion Kit
already installed on your saw, ensure
that the hold-down straps on the mobile
base have been secured to the saw
cabinet (these hold-down straps were
included with your ICS Mobile Base
with PCS Conversion Kit). If you did
not install them and no longer have
access to these straps, please contact
our Service Department for assistance:
service@sawstop.com or 503-582-9934.
NEXT: INSTALL THE ROUTER TABLE on either the Benchtop Stand or in-line.
See page 2 for details.
•
For mounting to the Benchtop Stand, proceed to the next page.
•
For mounting to the left extension wing of your Professional Cabinet Saw
or Contractor Saw, proceed to page 19.
i
The router table is only compatible with the SawStop Contractor Saw
if cast iron wings are installed. The standard stamped wings on the
Contractor Saw cannot support the weight of the router table.
•
For right mounting between the rails of your Professional Cabinet Saw,
proceed to page 19.
RT-TGP/RT-BT OWNER'S MANUAL
stamped
wing
12