Lockout / Tagout; Installing The Lockout Attachment - Epson LS-B Series Safety And Installation

1. Safety

1.8 Lockout / Tagout

Lockout / tagout is a method to prevent anyone from turning ON the robot system
by mistake while someone else is within the safeguarded area for maintenance or
repair.
When performing maintenance and repair, lockout and tagout using the following
procedure. Use the lockout attachment for RC90-B.

Installing the Lockout Attachment

(1) Turn OFF the POWER switch and place the lockout attachment on the
POWER switch.
Insert the pin in the holes under the retractable actuator.
(2) Turn the lockout
attachment.
34
Push the pin in the
direction of arrows, and
insert the pin in the holes.
(3) Install the lockout
Safety and Installation (RC90-B / EPSON RC+ 7.0) Rev.4
Lockout
Attachment
Hole
POWER
switch
attachment on the switch.
Pin
(4) Slide the pin to
the lock position.
Lock position