Table of Contents
Advertisement
2. Installation
2.5 Controller Installation
2.5.1 Installation Precautions
Environment conditions
For Cleanroom installation
Installation procedure
Cable
58
: The Controller must be used within the environmental conditions
described in their manuals. This product has been designed and
manufactured strictly for use in a normal indoor environment.
Using the product in the environment that exceeds the conditions
may not only shorten the life cycle of the product but also cause
serious safety problems.
: The Controller is not designed for clean-room specification. If it
must be installed in a clean room, make sure to install it in the
proper enclosure with adequate ventilation and cooling.
: Before performing any installation procedure, turn OFF the
Controller and related equipment, and then disconnect the power
plug from the power source.
Performing any replacement procedure with the power ON is
extremely hazardous and may result in electric shock and/or
malfunction of the robot system.
: Be sure to connect the cables properly. Do not allow unnecessary
strain on the cables. (Do not put heavy objects on the cables. Do
not bend or pull the cables forcibly.) The unnecessary strain on
the cables may result in damage to the cables, disconnection, and/or
contact failure.
Damaged cables, disconnection, or a contact failure is extremely
hazardous and may result in electric shock and/or improper
function of the system.
Safety and Installation (RC90-B / EPSON RC+ 7.0) Rev.4
Advertisement
Table of Contents
