Connected/Disconnected Module Detection - Mitsubishi Electric RD78G4 User Manual

• Because a portion of the setting items are not displayed in simple display, when there are deficiencies in
setting items that are not displayed, the "Output" window may display a warning or error by selecting [Close
with Reflecting the Setting].
If a warning is displayed, switch to detailed display and correct the items.
• Stations which have the station No. can be set up to 64 stations, and up to 64 stations can be set the
network configuration settings. When using extended modules supporting the CANopen communication,
one module is counted as one station.

Connected/Disconnected Module Detection

1.
Click the [Connected/Disconnected Module Detection] button.
2.
When the [Execute] button is clicked according to the instruction on the window, connected slave stations are detected
and displayed on the "CC-Link IE TSN Configuration" window.
3.
Check items in the list of stations and change them as necessary. ( Page 43 Setting items)
4.
Select [Close with Reflecting the Setting] and close the "CC-Link IE TSN Configuration" window.
Detection of connected/disconnected devices cannot be executed in the following cases.
• Link Direct Device Setting" of the CPU parameter is not "Extended Mode (iQ-R Series Mode)".
• The actual system configuration is incorrect. (Such as IP address duplication)
• The master station does not perform data link.
2 PARAMETER SETTINGS
44
2.5 "CC-Link IE TSN Configuration" Window