Door Latch Switch - Whirlpool AER5522VAS0 Manual

LCC Fault Code Procedure (continued)
F5 E1

(Door Latch Switch)

• Run Diagnostic Mode and verify
fault code
• While in Diagnostic Mode - Start
Clean cycle, to verify door does latch.
• Unplug range or disconnect power.
If door did not latch - check for
contunity at CON3-4 to CON3-1
• If no contunity - check for 500-3000Ω
resistance at CON1-4 to CON1-1
• If resistance check fails - replace
Latch motor.
• If resistance check is good, check
door (slot) and latching rod
alignment.
• If door alignment is good -
• Replace Door Latch Switch
1-
28