Lcc Standard Clean, Gas - Whirlpool AER5522VAS0 Manual

LCC90 Control, Standard Clean, GAS
LCC90 Control, Standard Clean, GAS
1. Press BAKE for 5 seconds.
2. Press TEMP/TIME "+" or "-".
1. Press BAKE for 5 seconds.
2. Press TEMP/TIME "+" or "-".
TEMP/HOUR
3. Press START.
3. Press START.
Action
1. Press CANCEL/CANCEL/START
2. Press the TEMP/TIME "+" key TEMP/HOUR
Action
Press "+" again
1. Press CANCEL/CANCEL/START
"+" again
2. Press the TEMP/TIME "+" key
"+" again
Press "+" again
"+" again
"+" again will display 1 of the 3
"+" again
"+" again
"+" again will display 1 of the 3
"+" again
"+" again
When checking for fault codes, if the display shows "CLr", Do Not replace the control.
"+" again

LCC Standard Clean, GAS

Temperature Adjustment
Previous Offset shown, or U-00 is displayed.
Temperature Adjustment
Adjusts temperature in 10⁰ F (5⁰ C) increments
between -30⁰F and +30⁰F.
Previous Offset shown, or U-00 is displayed.
Bake and Broil Temperatures are offset
Adjusts temperature in 10⁰ F (5⁰ C) increments
automatically to the same degree.
between -30⁰F and +30⁰F.
If START is not pressed within 1 minute, adjustment
Bake and Broil Temperatures are offset
is ignored.
automatically to the same degree.
If START is not pressed within 1 minute, adjustment
is ignored.
Diagnostic Mode
Diagnostic Mode
"tSt"
###⁰F or ⁰C
-30⁰F to +30⁰F
"tSt"
###
###⁰F or ⁰C
###
-30⁰F to +30⁰F
"CLr"
###
F# *(Error Code - See Tech Sheet for Repair) ##
###
##
(Hours of operation at error code)
"CLr"
####
F# *(Error Code - See Tech Sheet for Repair) ##
"00" (Door Open) or "01" (Door Closed)
(Hours of operation at error code)
*Press "START" to clear all fault codes
####
"00" (Door Open) or "01" (Door Closed)
1-
*Press "START" to clear all fault codes
Display
(You are in the test mode)
(Oven Sensor Temperature)
Display
(Oven Offset Temperature)
(You are in the test mode)
(Control Software Version)
(Oven Sensor Temperature)
(Control Memory Checksum)
(Oven Offset Temperature)
(Control Software Version)
(Control Memory Checksum)
(Hours of operation at error code)
(Total hours of oven operation)
(Total hours of oven operation)
8
Models:
SF114PXSB2
SF114PXSQ2
SF114PXST2
SF114PXSW2
WFG114SVB0
WFG114SVQ0
WFG114SVT0
WFG114SVW0
WFG231LVB0
WFG231LVQ0
WFG231LVS0
Models:
AGR4433XDB0
AGR4433XDS0
AGR4433XDW0
(Good Control)
(Good Control)