Whirlpool AER5522VAS0 Manual page 56

MRC II Control, Double Oven, True Convection (Lower), Dual Fuel
MRC II Control, Double Oven, True Convection (Lower), Dual Fuel
Press "OPTIONS" until "Temp Calib"
is displayed.
Press #3 or #6 keypads.
Press START.
Press CANCEL/CANCEL/START
Press the the number "3" key, follow
directions at each operation.
When in the Diagnostic mode, instructions will be provided by the control to help you through
each of the programs. Press Cancel to exit the test at any time.
When checking for Fault Codes and "NO FAULTS" is displayed. Do Not replace the Control.
The "AUTO TEST" program will automatically test all the oven circuits. This test is very easy to
use and when the test is complete, test results will be provided. Whenever servicing the oven,
this is the test to run.
Temperature Adjustment
Diagnostic Mode
Action
Press "3" again
"3" again
"3" again
"3" again
"3" again
"3" again
"3" again
*Press "START TIME" to clear all fault codes.
"DELAY START"
Previous Offset shown.
Adjusts temperature in 5⁰F (3⁰C) increments
between -30⁰F (-18⁰C) and +30⁰F (+18⁰C).
Bake and Broil Temperatures are offset
automatically to the same degree.
If START is not pressed within 1 minute,
adjustment is ignored.
Display
"TEST ON" ##⁰F "UO"
"CONTROL RESET" (Resets Control settings)
"USAGE" (Displays hours of Operation)
"ENG MODE" (Manufacturing Information)
"TEST MODE" (Manual Check of Control relays)
"VERSION" (Manufacturing Information)
"DISPLAY" (Checks all LEDs in Display)
"FAULTS" *(Displays all Fault Codes)
"AUTO TEST" (Performs a complete check of
the OVEN, automatically)
6
3-
Models:
KDRS505XSS00
(In the test mode)