Electrical Shock Hazard
No Faults - Control is good do not replace
No Display - Control is blank
MRC Fault Code Procedure
2-
Eletrical Shock Hazard
• Verify 120VAC between P6-1
1. Unplug range or disconnect
2. Connect voltage measurement
3. Plug in range or reconnect
4. Unplug range or disconnect
• Check wiring from control
• Check wiring from terminal
10
Do Not Replace Control
to P6-3 by completing the
following steps:
power.
equipment to P6-1 and P6-3.
power and confirm voltage
reading.
power.
board to terminal block.
block to power supply.