Whirlpool AER5522VAS0 Manual page 45

MRC Convection, Gas (continued)
MRC Control, Convection, Gas
Press "OVEN LIGHT" for 5 seconds.
Press TEMP/TIME "+" or "-".
Press START.
Action
1. Press CANCEL/CANCEL/START
2. Press the TEMP/TIME "+" key
Press "+" again
"+" again
"+" again
"+" again
"+" again
"+" again
"+" again
When in the Diagnostic mode, instructions will be provided by the control to help you through
each of the programs. Press Cancel to exit the test at any time.
The "AUTO TEST" program will automatically test all the oven circuits. This test is very easy to use
and when the test is complete, test results will be provided. Whenever servicing the oven, this is
the test to run.
*Press "DELAY START" to clear all fault codes
When checking for fault codes and "NO FAULTS" is displayed, do not change the control.
Temperature Adjustment
Previous Offset shown, or U-00 is displayed.
Adjusts temperature in 5⁰F (3⁰C) increments
between -30⁰F (-18⁰C) and +30⁰F (+18⁰C).
Bake and Broil Temperatures are offset
automatically to the same degree.
If START is not pressed within 1 minute, adjustment
is ignored.
Diagnostic Mode
"TEST ON" ##⁰F "UO"
"USAGE"
"ENG MODE"
"TEST MODE"
"VERSION"
"DISPLAY"
"CONTROL RESET"
"FAULTS"
"AUTO TEST"
the OVEN, automatically)
*Press "Delay Start" to clear all fault codes.
2- 8
Models:
MGR8772WB0
MGR8772WS0
MGR8772WW0
MGR8875WB0
MGR8875WB1
MGR8875WS0
MGR8875WS1
MGR8875WW0
MGR8875WW1
Display
(In the test mode)
(Displays hours of Operation)
(Manufacturing Information)
(Manual Check of Control relays)
(Manufacturing Information)
(Checks all LEDs in Display)
(Resets Control settings)
*(Displays all Fault Codes)
(Performs a complete check of