Whirlpool AER5522VAS0 Manual page 21

LCC Self-Clean, Electric (continued)
1. Press BAKE for 5 seconds.
2. Press TEMP/TIME "+" or "-".
3. Press START.
Action
1. Press CANCEL/CANCEL/START
2. Press the TEMP/TIME "+" key
Press "+" again
"+" again
"+" again
"+" again will display 1 of the 3
"+" again
"+" again
*Press "START" or "START TIME" to clear all fault codes
When checking for fault codes, if the display shows "CLr", Do Not replace the control.
Temperature Adjustment
Previous Offset shown, or U-00 is displayed.
Adjusts temperature in 10⁰ F (5⁰ C) increments
between -30⁰F and +30⁰F.
Bake and Broil Temperatures are offset
automatically to the same degree.
If START is not pressed within 1 minute, adjustment
is ignored.
Diagnostic Mode
"tSt"
or "tESt"
###⁰F or ⁰C
-30⁰F to +30⁰F
###
###
"CLr"
F# *(Error Code - See Tech Sheet for Repair) ##
##
(Hours of operation at error code)
####
"00" (Door Open) or "01" (Door Closed)
*Press "START" to clear all fault codes
1-
12
Display
(You are in the test mode)
(Oven Sensor Temperature)
(Oven Offset Temperature)
(Control Software Version)
(Control Memory Checksum)
(Hours of operation at error code)
(Total hours of oven operation)
(Good Control)