Mrc Ii Control, Double Oven, True Convection (Lower), Gas - Whirlpool AER5522VAS0 Manual

MRC II Control, Double Oven, True Convection (lower), Gas

Press "SETTINGS" until "Temp Calib"
is displayed.
Press TEMP/TIME "+" or "-".
Press START.
Action
Press CANCEL/CANCEL/START.
Press the TEMP/TIME "+" keypad,
follow directions at each operation.
Press "+"
"+" again
"+" again
"+" again
"+" again
"+" again
"+" again
When in the Diagnostic mode, instructions will be provided by the control to help you through
each of the programs. Press Cancel to exit the test at any time.
When checking for Fault Codes and "NO FAULTS" is displayed. Do Not replace the Control.
The "AUTO TEST" program will automatically test all the oven circuits. This test is very easy to
use and when the test is complete, test results will be provided. Whenever servicing the oven,
this is the test to run.
* Press "DELAY START" or "START TIME" to clear all fault codes.
MRC II Double Oven, Gas
Temperature Adjustment
Previous Offset shown, or U-00 is displayed.
Adjusts temperature in 5⁰F (3⁰C) increments
between -30⁰F (-18⁰C) and +30⁰F (+18⁰C).
Bake and Broil Temperatures are offset
automatically to the same degree.
If START is not pressed within 1 minute, adjustment
is ignored
Diagnostic Mode
"TEST ON" ##⁰F "UO"
"CONTROL RESET"
"USAGE"
"ENG MODE"
"TEST MODE"
"VERSION"
"DISPLAY"
"FAULTS"
"AUTO TEST"
OVEN, automatically)
*Press "DELAY START" to clear all fault codes.
3- 11
Models:
MGT8885XB00
MGT8885XS00
MGT8885XW00
Display
(In the test mode)
(Resets Control settings)
(Displays hours of Operation)
(Manufacturing Information)
(Manual Check of Control relays)
(Manufacturing Information)
(Checks all LEDs in Display)
*(Displays all Fault Codes)
(Performs a complete check of the