Lcc190 Control, Self Clean, Convection, Gas; Lcc190 Control, Self-Clean, Convection, Gas - Whirlpool AER5522VAS0 Manual

LCC Self Clean, Convection, Gas

LCC190 Control, Self Clean, Convection, Gas

LCC190 Control, Self-Clean, Convection, Gas

Press BAKE for 5 seconds.
Press TEMP/TIME or
TEMP/HOUR "+" or "-".
Press BAKE for 5 seconds.
Press TEMP/TIME or
Press TEMP/TIME "+" or "-".
TEMP/HOUR "+" or "-".
Press START.
Press START.
Action
Press CANCEL/CANCEL/START.
Press the TEMP/TIME or
Action
Press TEMP/TIME "+" key.
TEMP/HOUR "+" key.
Press CANCEL/CANCEL/START.
Press "+" again
Press the TEMP/TIME or
"+" again
TEMP/HOUR "+" key.
"+" again
Press "+" again
"+" again
"+" again will display 1 of the 3
"+" again
"+" again
"+" again will display 1 of the 3
"+" again
*Press "START TIME" or "DELAY START" to clear all fault codes
"+" again
When checking for fault codes and "GOOd" is displayed, do not replace the control.
"+" again
When checking for fault codes and "GOOd" is displayed, do not replace the control.
Temperature Adjustment
Previous Offset shown, or U-00 is displayed.
Temperature Adjustment
Adjusts temperature in 10⁰ F (5⁰ C) increments
between -30⁰F and +30⁰F.
Previous Offset shown, or U-00 is displayed.
Bake and Broil Temperatures are offset
Adjusts temperature in 10⁰ F (5⁰ C) increments
automatically to the same degree.
between -30⁰F and +30⁰F.
If START is not pressed within 1 minute, adjustment
Bake and Broil Temperatures are offset
is ignored.
automatically to the same degree.
If START is not pressed within 1 minute, adjustment
is ignored.
Diagnostic Mode
Diagnostic Mode
"tESt"
###⁰F or ⁰C
"tESt"
-30⁰F to +30⁰F
###
###⁰F or ⁰C
###
-30⁰F to +30⁰F
"CLr"
"GOOd"
###
*(Error Code - See Tech Sheet for Repair)
F# *(Error Code - See Tech Sheet for Repair) ##
###
##
(Hours of operation at error code)
"CLr"
####
F# *(Error Code - See Tech Sheet for Repair) ##
"00" (Door Open) or "01" (Door Closed)
(Hours of operation at error code)
*Press "START" to clear all fault codes.
####
"00" (Door Open) or "01" (Door Closed)
1-
24
*Press "START" to clear all fault codes.
Models:
MGR7775WB0
MGR7775WB1
MGR7775WS0
MGR7775WS1
MGR7775WW0
MGR7775WW1
Models:
AGR6011VDB0
AGR6011VDB1
AGR6011VDS0
AGR6011VDS1
AGR6011VDW0
AGR6011VDW1
Display
(You are in the test mode)
Display
(Oven Sensor Temperature)
(You are in the test mode)
(Oven Offset Temperature)
(Control Software Version)
(Oven Sensor Temperature)
(Control Memory Checksum)
(Oven Offset Temperature)
(Good Control)
(Control Software Version)
(Control Memory Checksum)
(Hours of operation at error code)
(Good Control)
(Total hours of oven operation)
(Total hours of oven operation)
B, D, E, F, M
B, D, E, F, M