S5-Fb250 Format; Table 39: Id 9, Setting Ni1000 (Tk5000), S5-Fb250 Format - WAGO 750-451 Manual

48 Process Image
4.3.11.2

S5-FB250 Format

With the setting "Ni1000 (TK5000)" and activated S5-FB250 format, the I/O
module converts the measured resistance values of Ni1000 sensors (TK5000) into
temperature values and outputs the conversion results.
The temperature values are displayed at a resolution of 1 digit per 0.05 °C.
The status information is depicted in bit 0 to bit 2 and the digitalized measured
value in bit 3 to bit 15.

Table 39: ID 9, Setting Ni1000 (TK5000), S5-FB250 Format

Temperature
°C
---
Short circuit
< −50.0
Underrange
−50.0
−25.0
0.0
50.0
100.0
125.0
150.0
> 150.0
Overrange
---
Wire break
1) Temperature values below 0 °C are represented in two's complement binary.
2) When short circuit and wire break monitoring is ON (see section "Diagnostics" > „Behavior in
the Event of an Error")
3) When underrange / overrange limit is ON (see section "Diagnostics" > „Behavior in the Event
of an Error")
4) Status information:
X: Not used,
F: Short circuit, wire break,
Ü: Underrange, overrange
Numeric value
Resistance
Ω
Binary
< 10.00
'1110.0000.1100.0 010'
2)
< 790.88
'1110.0000.1100.0 001'
3)
790.88 '1110.0000.1100.0 000'
892.47 '1111.0000.0110.0 000'
1000.00 '0000.0000.0000.0 000'
1234.98 '0001.1111.0100.0 000'
1500.00 '0011.1110.1000.0 000'
1645.10 '0100.1110.0010.0 000'
1799.27 '0101.1101.1100.0 000'
> 1799.27
'0101.1101.1100.0 001'
3)
> 5010.00
'0101.1101.1100.0 010'
2)
WAGO-I/O-SYSTEM 750
1)
with status information
XFÜ Hex. Dec.
0x E0C2 −7998
0x E0C1 −7999
0x E0C0 −8000
0xF060 −4000
0x0000
0x1F40 8000
0x3E80 16000
0x4E20 20000
0x5DC0 24000
0x5DC1 24001
0x5DC2 24002
750-451 8 AI RTD
Status
4)
Error
byte
LED
hex.
0x50 ON
0x41 ON
0x00 OFF
0x00 OFF
0 0x00 OFF
0x00 OFF
0x00 OFF
0x00 OFF
0x00 OFF
0x42 ON
0x60 ON
Manual
Version 1.1.0