Connecting The Tc-Net 100 Cable - Toshiba TC-net 100 Instruction Manual

Chapter 2 Installation and Wiring
2.2

Connecting the TC-net 100 Cable

Connect the TC-net 100 cable (optical fiber code) to the TN8 module.
Connecting the optical fiber cord (TN821/TN821A, TN822/TN822A)
Connect the optical fiber cord to the MT-RJ type optical connectors
(TN-A and TN-B) as shown below.
6F8C1360
10
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the human body
may cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause
malfunction or accidents.
Perform a notification check in the application
CAUTION
level using the transmission protocol.
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's
service representatives.
If you have any question, consult with one of
Toshiba's service representatives.
Remove the dust cover of the optical connector.
Remove the dust cover of the optical connector. Pinch the dust cover with
your fingers until it clicks, and then remove it.
Connect the optical fiber cord.
Insert the optical fiber cord into the MT-RJ type connector, and press it in
until it clicks.
Secure the cable.
Secure the cable by clamping it so that no stress is exerted on the cable.
Mandatory
Prohibited
Mandatory