Installation (Installation To The Basic Unit) - Toshiba TC-net 100 Instruction Manual

Chapter 2 Installation and Wiring
2.1

Installation (Installation to the Basic Unit)

6F8C1360
8
Before installing or removing the module,
WARNING
make sure that the basic unit to which the TN8
module is installed is turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product except
WARNING
the switches.
It may cause an electric shock.
Install it under an environment that satisfies
CAUTION
the product specifications.
When installing it under an environment that does
not satisfy the product operating temperature range,
apply forced cooling with cooling equipment.
Operating temperature range: 0 to 55°C
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the human body
may cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause malfunction
or accidents.
When installing the product to the basic unit,
CAUTION
do not bend the pins of the station bus
connector.
If it is difficult to insert the module to the basic
CAUTION
unit, remove it once and try again rather than
forcing it.
Use a Phillips screwdriver.
CAUTION
To prevent damage to the screws, use a screwdriver
that is suitable for the screws.
Perform a notification check in the application
CAUTION
level using the transmission protocol.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Mandatory