Toshiba TC-net 100 Instruction Manual page 47

3.4 Network Information
Sending node: Specify the transmission module that sends the block.
Output controller: Specify the controller that uses the block.
Figure 3-19 An example of scan sending blocks registration
Check the setting of the scan sending blocks.
Open the parameter screen of the TN8 module, and select the [Sending
Block] tab.
The transmission speed and information about the slot in which the output
controller using the block are displayed for the registered scan sending
block.
Figure 3-20 Parameter screen of Sending blocks
Unified Controller nv series TC-net 100 (TN8) Module Operation Manual
33