Chapter 3 Setting
36
6F8C1360
Download the registered data to the TN8.
After checking the data, download it to the TN8 module.
To download, display the parameter information, and select [File
(F)]->[Download (D)].
Note
• If the controller is in a redundant configuration, download the module parameters of the TN8
by selecting [Primary (P)] and [Secondary (S)] from [Transmission Destination].
Restart it.
The downloaded information becomes effective upon the next startup.
After the download is complete, restart it.
Check the registered data.
After the download, display the state change notification parameter screen
again, and select [View] -> [Tools and Modules] to confirm that the
information of TN8 module can be read.
Figure 3-23 An example of reading the state change notification information
According to an example of table 3-23, "point No.2" in [Tool] moves up to "point No.1"
in [Module], because "point No.1" is registered "No".
Then, GET_IP_INF command outputs "point No.1".
Move up