Table of Contents
Advertisement
Setting the thread cutter
13.3 Setting the pneumatic cylinder lever
Proper setting
When the thread cutter is in its initial position, the distance between the
piston and the base of the pneumatic cylinder is 0.5 - 1 mm.
Cover
• Tilt the machine head ( p. 14)
Fig. 63: Setting the pneumatic cylinder lever
(1) - Assembly opening
(2) - Lever
(3) - Piston
To set the pneumatic cylinder lever:
1. Turn the lever (6) such that it rests against the pin (5).
2. Loosen the screw for the lever (2) through the assembly opening (1).
3. Turn the lever (2) until the piston (3) makes contact with the base of
4. Turn the lever (2) slightly back until there is gap between the piston (3)
5. Tighten the screw for the lever (2) through the assembly opening (1).
Service Instructions 969 - 06.0 - 03/2019
①
②
③
④
the pneumatic cylinder (4).
and the base of the pneumatic cylinder (4) that is approx. 0.5 - 1 mm
wide.
(4) - Pneumatic cylinder
(5) - Pin
(6) - Lever
⑥
⑤
81
Advertisement
Table of Contents
