3. Turn the lift lever (3) such that there is a clearance of 0.3 to 0.5 mm between
4. Tighten the screw (2).
12.2 Adjusting the foot stroke generated by the pneumatic
Proper setting
The stroke of the presser foot generated by the pneumatic cylinder is
30 mm.
Fig. 47: Adjusting the stroke of the feet generated by the pneumatic cylinder
①
②
③
(1) - Counternut
(2) - Screw
Setting steps
1. Put the handwheel into the 0° position ( p. 20). The presser foot (3)
2. Loosen the counternut (1).
3. Activate the pneumatic lifting of the foot
The presser foot (3) is lifted.
4. Turn the screw (2) until the height of the presser foot (3) is 30 mm above
5. Tighten the counternut (1).
66
the lift lever (3) and the drive dog (4).
cylinder
rests on the throat plate.
( see Operating Instructions 967).
the throat plate.
Adjusting the foot stroke
(3) - Presser foot
Service Instructions 967 - 02.0 - 12/2015