Table of Contents
Advertisement
11.2.2 Setting the foot stroke using the pneumatic cylinder
Proper setting
When set by pneumatic cylinder, the presser foot stroke is 30 mm.
Fig. 51: Setting the foot stroke using the pneumatic cylinder
(1) - Screw
(2) - Counternut
To set the foot stroke using the pneumatic cylinder:
1. Move the handwheel into the 0° position.
The presser foot rests on the throat plate.
2. Loosen the counternut (2).
3. Activate the pneumatic foot lift ( Operating Instructions).
The presser foot is lifted.
4. Turn the screw (1) until the presser foot (3) is positioned 30 mm above
5. Tighten the counternut (2).
68
①
②
③
the throat plate.
Setting the sewing feet
(3) - Presser foot
Service Instructions 969 - 06.0 - 03/2019
30 mm
Advertisement
Table of Contents
