Table of Contents
Advertisement
11.1.4 Setting the stroke movement for the feeding foot
In order to ensure a correct feed, the stroke movement for the feeding
foot must be aligned to the stroke movement for the feed dog.
Proper setting
The left adjusting wheel for the sewing foot stroke is set to maximum
stroke.
The upper stitch length adjusting wheel is set to 0.
The feeding foot touches down exactly on the feed dog when the
Cover
• left and right arm cover ( p. 15)
Fig. 49: Setting the stroke movement for the feeding foot
(1) - Feeding foot
(2) - Feed dog
(3) - Needle tip
(4) - Threaded pins
To set the stroke movement for the feeding foot:
1. Screw in the threaded pin (7) so that there is a stroke.
2. Set the upper stitch length adjusting wheel to 0.
3. Loosen the threaded pins (4).
4. Turn the stroke eccentric (5) so that the feeding foot (1) touches down
Important
Ensure not to move the stroke eccentric (5) laterally on the axle.
5. Tighten the threaded pins (4).
6. Loosen the threaded pin (7) far enough so that the clips (6) are in a
66
downward movement of the needle tip reaches the upper edge of
the feeding foot.
This occurs at handwheel position 95°.
①
②
on the feed dog (2) when the handwheel is in the 95° position and the
tip of the needle (3) is at the height of the upper edge of the feeding
foot (1).
line again.
③
④
(5) - Stroke eccentric
(6) - Plates
(7) - Threaded pin
Service Instructions 969 - 06.0 - 03/2019
Setting the sewing feet
⑦
⑥
⑤
Advertisement
Table of Contents
