Setting the sewing feet
Fig. 48: Setting the feed stroke of presser foot and sewing foot
(1) - Presser foot
(2) - Working position
(3) - Plate
To set the feed stroke of presser foot and feeding foot:
1. Move the handwheel into the 0° position.
2. Set the stitch length to 0.
3. Set the zero stroke of the feet ( p. 61).
4. Loosen the screw (5).
5. Place the plate (3) under the feet so that the feeding foot (4) is 0.3 mm
6. Manually move both feet down as far as they will go.
7. Tighten the screw (5).
Service Instructions 969 - 06.0 - 03/2019
①
②
③
lower than the presser foot (1).
④
(4) - Feeding foot
(5) - Screw
⑤
65