Setting The Drive Pulley - DURKOPP ADLER 969 Service Instructions Manual

Setting the drive

6.2.2 Setting the drive pulley

Proper setting
The pulleys are in alignment.
Fig. 19: Setting the drive pulley
(1) - Driven pulley
(2) - Screws
To set the drive pulley:
1. Loosen the screws (3).
2. Pull the drive pulley (2) off the motor shaft and put it back on the other
3. The drive pulley (2) and the driven pulley (1) are in alignment.
4. Tighten the screws (3).
Service Instructions 969 - 06.0 - 03/2019
①
②
way round.
③
(3) - Drive pulley
31