Table of Contents
Advertisement
6.1.2 Setting the drive pulley
Proper setting
Regardless of which side of the drive pulley (2) is being used, there is a
difference in height of 16 mm between the faces of the two pulleys.
Fig. 16: Setting the drive pulley
①
②
③
(1) - Driven pulley
(2) - Drive pulley
To set the drive pulley:
1. Loosen the screws (3).
2. Pull the drive pulley (2) off the motor shaft and put it back on the other
3. Set a height difference of 16 mm between the faces of the drive
4. Tighten the screws (3).
28
16 mm
higher speed
way round.
pulley (2) and the driven pulley (1).
Setting the drive
16 mm
greater penetration force
(3) - Screws
Service Instructions 969 - 06.0 - 03/2019
Advertisement
Table of Contents
