Dc Power Input Connector (Con1); Dc Power Cable Specification - Equinox Systems FS2003 User Manual

1.6 DC Power Input Connector (CON1)

It is possible to power the programmer from an external power supply by plugging the DC Power
Cable supplied with the programmer into CON1. This connector is a 2.5mm jack socket.
Fig. 1.6.1 CON1 – pin-out
Description
Centre pin
Outer

1.7 DC Power Cable Specification

The programmer is supplied with a DC power cable which plugs into CON1. The other end of
this cable is supplied with bare wire ends for connecting to an external power supply e.g.
bench PSU.
Cable Specification:
•
One end features a female 2.5mm DC jack plug
•
The other end of the cable is supplied with bare wire ends for connecting to an external power
supply e.g. bench PSU.
•
The black lead with the white stripe is the +VE cable.
•
The all black lead is the GROUND cable.
•
The external voltage applied to CON1 must be between 9.0 and 12.0V!
FS2003 ISP Programmer - User Guide V1.07 – 1
Voltage
+9.0V to +12.0V from external power supply
0V (Ground connection)
st
September 2007 19