Equinox Systems FS2003 User Manual page 66

5 PROG_RESET O
6 PROG_GND
Key
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive eg. GROUND and power rails
N/C - Not connected
FS2003 ISP Programmer - User Guide V1.07 – 1
RESET
P GROUND
Target RESET control pin
This pin controls the Target Device
RESET pin. It will driven HIGH/LOW
according to the device type and settings
in the 'Pre-program State Machine' tab in
the Eqtools project.
Ground Connection
Common ground connection between
PROGRAMMER and Target System.
st
September 2007 63