Table of Contents
Advertisement
3
PROG_TSCK2 O
4
PROG_MOSI
5
N/C
6
PROG_MISO
7
PROG_GND
8
PROG_SCK1
9
PROG_GND
10
PROG_RESET O
FS2003 ISP Programmer - User Guide V1.07 – 1
XTAL1
Only connect this pin if
you are using the
SCK2 Clock Output to
clock the Target
Device during
programming!
O
MOSI
(except for
ATmega103/128/64 –
connect to RXD pin
instead)
O
N/C
I
MISO
(except for
ATmega103/128/64 –
connect to TXD pin
instead)
P
GROUND
O
SCK
P
GROUND
RESET
SCK2 Clock Output (*Optional*)
This output signal can be used to
supply an external clock signal
(SCK2) to the target microcontroller.
This function must be enabled in the
EQTools <Pre-programming State
Machine> tab. If the SCK2 oscillator
is not being used, then the pin could
be used as a spare output pin.
Master Out Slave In
This is the SPI data output pin from
the programmer. This pin should be
connected to the MOSI pin on the
Target Microcontroller.
Not connected
Master In Slave Out
This is the SPI data input pin to the
programmer. This pin should be
connected to the MISO pin on the
Target Microcontroller.
Ground Connection
Common ground connection between
PROGRAMMER and Target System.
SPI Serial Clock Output
This is the SPI clock output signal
used to clock data into / out of the
Target Device.
Ground Connection
Common ground connection between
PROGRAMMER and Target System.
Target RESET control pin
This pin controls the Target Device
RESET pin. It will be driven
HIGH/LOW according to the device
type and settings in the <Pre-program
State Machine> tab in the Eqtools
project.
Warning!
During 'High Voltage Serial
Programming' of the Atmel
ATtiny11/12/15 microcontrollers, a
+12V Vpp voltage is generated by the
programmer on this pin.
st
September 2007
65
Advertisement
Table of Contents
