Equinox Systems FS2003 User Manual page 73

5 N/C
6 PROG_RXD
7 PROG_GND
8 PROG_ACTIVE
9 PROG_GND
10 PROG_RESET
Key
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive eg. GROUND and power rails
N/C - Not connected
70
- N/C
I TXD
P Ground
Connection
O LED or
Interrupt pin
P Ground
Connection
O RESET
FS2003 ISP Programmer - User Guide V1.07 – 1
Not Connected
Programmer RXD (Transmit) pin
The programmer receives serial data on
this pin from the Target Device TXD
(Transmit) pin.
Target / Programmer GROUND
connection
Common ground connection between
PROGRAMMER and Target System.
Programmer ACTIVE LED
This pin can be driven LOW when a
programming action is taking place. The
signal can be used to illuminate an LED or
trigger an interrupt on the Target
Microcontroller.
Target / Programmer GROUND
connection
Common ground connection between
PROGRAMMER and Target System.
Target RESET control pin
This pin controls the Target Device RESET
pin. It will driven HIGH/LOW according to
the device type and settings in the 'Pre-
program State Machine' tab in the Eqtools
project.
Warning!
During 'High Voltage Serial Programming'
of the Atmel ATtiny11/12/15
microcontrollers, a +12V Vpp voltage is
generated by the programmer on this pin.
st
September 2007