Powering The Target System At +5.0V From The Programmer (External Mains Power Supply Adaptor); Powering The Target System At +5.0V From The Programmer (External Bench Power Supply) - Equinox Systems FS2003 User Manual

2.4.2 Powering the Target System at +5.0V from the programmer (external
mains power supply adaptor)
2.4.3. Powering the Target System at +5.0V from the programmer
(external bench power supply)
26
•
Plug power supply jack into mating jack
socket CON 1 on the rear of the
programmer.
•
External power supply must be 9.0 to
12.0V DC regulated (9.0V DC regulated
power supply is supplied with the
programmer).
•
Fit the Jumper J9 which connects the
programmer +5.0V Vcc supply to the
Target Vcc on the ISP Header
connectors.
•
Plug the mains adaptor into the mains
supply but do not switch the power on.
•
The programmer is supplied with a DC
power cable with a jack plug on one end
and bare wires at the other end.
•
Plug the jack plug into the mating jack
socket CON 1 on the programmer.
•
Connect the bare wire ends to a suitable
external power supply e.g. bench power
supply.
•
The wire with the WHITE STRIPE on it is
+VE and the all black wire is –VE
(GROUND).
•
The external power supply must be 9.0
to 12.0V DC regulated
•
Fit the Jumper J9 which connects the
programmer +5.0V Vcc supply to the
Target Vcc on the ISP Header
connectors.
•
If you have a 'Current Limit' setting on
your Power Supply, set it to the minimum
value to start with and then increase it
until the programmer powers up without
tripping the Current Limit.
FS2003 ISP Programmer - User Guide V1.07 – 1
st
September 2007