Table of Contents
Advertisement
1.4 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
1
Target Device
Support
2
Target Device
Programming
Interfaces
3
Operating modes
4
On-board FLASH
Memory Store
5
Project storage in
Memory Store
6
Keypad entry
7
Status LED's
8
Programmer Display 2 x 16 character Back-lit LCD (backlight configurable)
9
Target Vcc
FS2003 ISP Programmer - User Guide V1.07 – 1
Description / comment
See Device Support List
The programmer supports the following programming interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
•
Philips (NXP) 8051 - Boot Loader ISP
The programmer supports the following operating modes:
As standard:
•
Development Mode (PC controlled)
•
Project Upload Mode using Upload Wizard (PC
controlled)
•
Standalone Mode - Keypad + LCD operation
•
Standalone Mode – Run Target
•
ConsoleEDS EVAL – Command Line control
Optional chargeable upgrades:
•
Standalone Mode - Remote Controlled via 'ASCII Text
Communications' RS-232 Serial Protocol
•
PC controlled via ISP-PRO software (chargeable
upgrade)
•
ConsoleEDS PRO – Command Line control
32 Mbits (4 MBytes) FLASH Memory
64 x Independent Programming Projects
4 x Push Button - <YES>, <NO>, <UP>, <Down>
3 x Status LED's located on the programmer:
<PASS>, <BUSY>, <FAIL>
These LED's indicate the current status of the programmer.
•
Target Vcc LED will illuminate when Target Vcc voltage is
st
September 2007
Refer
to
sect
1.5.1
1.5.2
3.4
13
Advertisement
Table of Contents
