Equinox Systems FS2003 User Manual page 51

In Standalone Mode you can:
•
Select from 1 of up to 64 Independent Programming Projects using the keypad and display
•
Plug the Programmer ISP cable into a Target System
•
Program the selected Programming Project into the Target Device
•
Unplug the Programmer ISP Cable from the Target System
•
Plug the Programmer ISP Cable into the next Target System
•
Repeatedly program the same Programming Project once it is selected
To execute a Programming Project in Standalone Mode:
# Action
1 Connect the programmer to a spare PC COM
port
2 Apply power to the Programmer / Target
System
3 Upload your 'Programming Project(s)' to the
programmer
4 Disconnect power from the Programmer /
Target System
5 Disconnect the serial lead from the
programmer
6 Follow the instructions to program the Target
Device in Standalone Mode
48
Observation / comment
Programmer Target Vcc LED illuminates
See EQTools Manual – Project Upload Wizard
for full instructions.
Programmer is no longer controlled from PC
FS2003 ISP Programmer - User Guide V1.07 – 1
st
September 2007