Equinox Systems FS2003 User Manual page 54

4. Wait for the programmer to CRC check the Programming Project
•
The programmer performs a full CRC validation check of the entire Programming Project
stored in the programmer 'FLASH Memory Store'.
•
If the check is OK, the programmer goes to step (5).
•
If the check FAILS, the programmer will display 'Internal Image is corrupted'. Please try re-
uploading your Project Collection and then repeat the Standalone Mode process from the
beginning.
LCD Display
CHECKING IMAGE
PAGE n
5. Press the RED <YES> button again to execute the Programming Project
•
The Programming Project will now start to execute.
•
The <BUSY> LED will illuminate to denote that the programmer is active.
•
This may take a few seconds or a few minutes depending on the nature of the Programming
Project.
•
The Programming Project will either PASS or FAIL
LCD Display
Current programming
operation is displayed
6. Programming Project – PASS
If the Programming Project programs the target device without any errors:
•
The <PASS> LED will FLASH
•
The LCD will display: 'Operation Complete OK!'
•
Press <YES> key to program another device
LCD Display
OPERATION
COMPLETE OK
FS2003 ISP Programmer - User Guide V1.07 – 1
Buttons Status LED
Display
Buttons Status LED
Display
To abort the
programming
sequence at any
time, press
Buttons Status LED
Display
Press
To program
another device.
st
September 2007 51