Table of Contents
Advertisement
2.5 Selecting the correct ISP (In System Programming) Header
a
Select the required ISP Header and then plug the ISP Cable into this Header.
Please refer to section 4 of this manual for full details of all the available headers.
b
Connect the ISP cable to the ISP Header on your Target System
Make sure the programmer and Target System Power is switched OFF !
Make sure that the ISP Cable plug is inserted the correct way around into the ISP Header on
the Target System.
Important note:
Please refer to the relevant Application Note for details of how to connect the programmer to the
Target Device on the Target System. The Application Notes can be found on the FS2003 -
Download Page on the Equinox website.
28
FS2003 ISP Programmer - User Guide V1.07 – 1
st
September 2007
Advertisement
Table of Contents
