Re-Assembling The Programmer - Equinox Systems FS2003 User Manual

2.9 Re-assembling the programmer

a Re-fit lid to programmer
b Re-fit the four screws in the back of the case
c Ensure that the PC, programmer and Target
System power is switched OFF.
Please note:
•
The FAIL LED will flash when you initially power up the programmer if you are running
firmware 2.46 or below.
•
If you are running firmware version 2.46 or greater the FAIL LED will no longer FLASH.
•
To clear the FAIL LED condition, use the <Up> / <Down> keys to select a Programming
Project and then press the <Yes> key .
•
If there are no Programming Projects Loaded into the Programmer – Flash Memory Store,
the FAIL LED will continue to FLASH until at least one Project is uploaded.
Hardware installation is now complete.
FS2003 ISP Programmer - User Guide V1.07 – 1
The ISP Cable should fit through the slot in the
end panel.
st
September 2007 33