Table of Contents
Advertisement
Key:
S – Device supported as standard
U – Chargeable license upgrade required
* – Support to be announced – please contact Equinox for a Support Date
For an up-to-date Device Support list, please refer to the 'Device Support' section for this programmer
on the Equinox Website.
Important note:
Please refer to the relevant Application Note for details of how to connect the programmer to the
Target Device on the Target System. The Application Notes can be found on the FS2003 -
Download Page on the Equinox website.
1.5.2 Programming Interface to Target Device
The programmer supports the following programming interfaces to the Target Device:
#
Programming
Family
Interface
1
LV SPI
AT89S
AT90S
AT90USB
AT90CAN
ATmega
ATtiny
Zensys
2
HV SPI (+12V
ATtiny
Vpp)
T89C51Rx2
3
UART Boot
P89X51Rx2
Loader
4
JTAG
ATmega
(Atmel AVR)
AT90USB
AT90CAN
Please note:
A chargeable license upgrade is required to enable the ATmega JTAG ISP libraries.
18
Description / Comment
Atmel Low Voltage Serial Programming Mode
•
Atmel 3-wire SPI interface (SCK, MOSI, MISO )
•
Target Device RESET
•
Works at target voltage (no Vpp required)
Atmel High Voltage Serial Programming Mode
•
Atmel 4-wire SPI Interface (SCK, MOSI, MISO, MOSI2)
•
+12V Vpp is applied to the RESET pin to enter High
Voltage Serial Programming Mode
•
Requires different connections to Target Device
compared with LV SPI.
•
Requires all pins of target device to be accessible by the
programmer.
Atmel / Philips UART Boot Loader Interface
•
Uses RXD, TXD, PSEN, and Target Device RESET pin
•
TTL Levels from programmer to Target System
Atmel ATmega AVR – JTAG ISP Interface
•
Uses same connector as Atmel JTAG ICE
•
A chargeable license upgrade is required to enable the
ATmega JTAG ISP libraries.
FS2003 ISP Programmer - User Guide V1.07 – 1
st
September 2007
Advertisement
Table of Contents
