Equinox Systems FS2003 User Manual page 10

FS2003 ISP Programmer - User Guide V1.07 – 1
Configit – Firmware Upgrade Utility
This utility is used to upgrade the firmware of the programmer. A
firmware update may be required to add support for new devices and
to correct any firmware issues.
Labview – Remote Application Control – Application Note
This upgrade allows a production facility to control a single
programmer from a 'Labview for Windows' application. The
Application note describes how to control the programmer using a
custom Labview (from National Instruments) application.
The following sources of documentation are available for this
software:
•
Application Note - Remote Application Control of ISP-PRO
Remote Application Control – Application Note
Describes how to control the programmer using a custom Remote
Application written in e.g. Visual Basic, C++, C Builder, Delphi etc.
ConsoleEDS Pro – Application note
This software utility allows any Equinox programmer to be controlled
via simple Command Line instructions from a Command Window
within Windows.
The following sources of documentation are available for this
software:
•
Application Note 111 – ConsoleEDS Manual
JTAG In-System (ISP) Upgrade – Application Note
This license upgrade enables the FS2003 Programmer to support
high-speed In-System Programming (ISP) of the Atmel ATmega
microcontroller family using the JTAG algorithm.
The following sources of documentation are available for this
software:
•
Application Note.
Error Message Descriptions
This document lists all the possible error messages which can be
generated by the EQTools / ISP-PRO applications.
st
September 2007 7