Rear Panel Idc Connector Ports And Signal Routing - Equinox Systems ISPnano IV-ATE Series Hardware User Manual

1.3 Rear Panel IDC Connector Ports and signal routing

The 'ISPnano Series IV ATE' programmer features three 'IDC Ports' as detailed in the illustration
below.
The purpose of each connector is described in the table below.
Connector
name
Target ISP Port
TTL Control Port
(opto-isolated)
Remote Control Port This port is used to remotely control the programmer from an
Lid Switch Connector This connector allows a test fixture lid switch to trigger the
ISPnano Series IV-ATE Programmer - User Manual - V1.04 – 21/02/2014
This port connects to the Target Device (UUT) on the Target
System. It bypasses any connections to the I/O Connector
Module.
This port is used to remotely control the programmer from an
external ATE / ICT or PLC. All signals are opto-isolated.
external ATE / ICT or PLC.
execution of a standalone programming project.
Description
Connector
type
16-way IDC
10-way IDC
14-way IDC
2-way molex
5