Programmer Operating Modes - Equinox Systems FS2003 User Manual

3.4 Programmer Operating Modes

The FS2003 programmer can be controlled in various different ways as detailed in the table below:
# Programmer Connect
Mode to PC
COM
Port
1 Development Yes
Mode
2 Standalone No
Mode
3 Script Mode Yes
4 ConsoleEDS Yes
FS2003 ISP Programmer - User Guide V1.07 – 1
Control Method Upgrade
/ Software License
Required
EQTools - EDS Standard
Feature
None Standard
Feature
EQTools – Script Upgrade
Debugger Required
or
ISP-PRO
ConsoleEDS Upgrade
Required
st
September 2007
Functional description
In this mode, the programmer
is controlled by EQTools -
Equinox Development Suite
(EDS). EDS allows you to
read/write the target device
FLASH / EEPROM / FUSE /
LOCK bits interactively under
PC control without uploading
a 'Programming Project' to
the programmer.
In this mode, the programmer
is not connected to a PC and
can program a single
'Programming Project' into
the Target Device when the
<YES> key is pressed. (A
valid project must have been
previously uploaded to the
programmer using EQTools –
Upload Wizard.)
In this mode, the programmer
is controlled from a
'Programming Script' running
within either the EQTools or
ISP-PRO applications on a
PC.
In this mode, the programmer
is controlled via the
ConsoleEDS utility which
allows control via simple
Command Line commands
and arguments.
Refer
to
section
3.5
3.6
3.8
See
App
Note
AN111
39