Table of Contents
Advertisement
4.2 Power Connectors (rear panel)
The PPM3 rear panel power connectors are shown in the figure below. The Jack Socket and 2-way
Molex connectors are wired in parallel internally. The input voltage for both connectors is 9.0 to 12.0V
DC regulated from an external power supply.
Fig. 3.2.1 PPM3 Module – Rear Panel Connectors
Key No
Function
1
DC Power Input (1)
2
DC Power Input (2)
4.3 DC Power Cable Specification
The programmer is supplied with a DC power cable which plugs into the DC power connector jack
socket on the rear panel of the programmer. The other end of this cable is supplied with bare wire
ends for connecting to an external power supply. e.g. bench PSU.
Cable Specification:
•
One end features a female 2.5mm DC jack plug
•
The other end of the cable is supplied with bare wire ends for connecting to an external power
supply. e.g. bench PSU.
•
The black lead with the white stripe is the +VE cable.
•
The all black lead is the GROUND cable.
•
The external voltage applied to the Jack Socket connector must be between 9.0 and 12.0V DC
regulated !
PPM3 MKII Programmer - User Guide - V1.04 - 10
Further description
•
2.5mm Jack socket (centre positive)
•
Input voltage: 9.0 – 12.0V DC regulated
•
2-way Molex connector
•
Input voltage: 9.0 – 12.0V DC regulated
•
This connector is wired internally in parallel with
the jack socket input (1).
th
May 2008
57
Advertisement
Table of Contents
